Elinvader1

Thanks for the information Autobot ...Kinda of busy from work , that's why I took lo ng time to reply....but I will look into it ...Thanks again..

Dedicated lines are the only way to fly
I had them put a surge protector at the breakers. Ran 8 awg then reduced to 10 awg at the outlet and the outlets must be isolated ground.
Also very important is that each outlet needs to be on the same phase.
Yours may not cost as much I had to have an additional breaker box mounted outside since the box in the house was full and had to run conduit all the way around the house and through the wall in the garage. My cost was $1,422.00.
here is a link that I got my ideas from. http://www.msbtech.com/support/wirin...ge=supportHome

Thank you for the comment in my gallery the Crown Macro-tech 12000i is extremely powerful and sounds pretty amazing for a pro amp although I have grown tired of the fan noise so I am selling it.
I have an electrician coming over today to run 3 dedicated lines and have 2 Emotiva XPR-1 mono blocks arriving today. Losing 2200 watts by doing this but think it will still have plenty of headroom with 1000 watts per channel.
More pics will be added as the project develops.

Thanks for the generous rating on my gallery!

Thanks for the pics! Actually I was thinking of building but I won't have time. I'm going to buy the 4" risers from Elemental Designs tomorrow! I have to buy 2 which sucks.

Yeah, will play with the suggested settings.

Thanks for your time.

Got it.
Its TCP50U1.
Does that website have calibrations for this specific model?

I am embarrased to say it but I dont know.
Do you know how I can know it?

On my manual it says instructions for
-TC-P42U1
-TC-P46U1
-TC-P50U1

Well in the review it's for a p50s2....

Thanks a lot.
Just have to check if thats for my particular TV or does it even really matter as long as its Panasonic?