View Single Post
Old 05-26-2017, 01:41 PM   #2099
shield80 shield80 is offline
Special Member
 
shield80's Avatar
 
Oct 2010
77
899
423
3
Default

So 2pt low when adding you are raising brightness,lowering 2pt you are lowering brightness.

if you reduce 2 point low (especially green), that will cause you to need to raise brightness from the default of 50 to whatever it takes to offset the amount of low you subtracted

And after low green -25 you then correcting the impact by calibrating the grayscale
  Reply With Quote