Paradigm PBK software update!!

[Maleku]

2.0 is out now. Seems to have some nice improvements:

Change Log:

v2.0:

As there are major changes since v1.04 a new Automatic-mode measurement is strongly recommended.

1. Added subwoofer positioning helper under Advanced mode / Tools / Quick Measure. This sweeps the subwoofer continuously to instantly show uncorrected frequency response graph. This can be most useful for finding a location for the subwoofer, since bass resonances vary greatly according to positioning. Approximately ten sweeps are needed before graph is shown - after that update is live.

NOTE: Follow Quick Measure with a full PBK procedure.

2. Where applicable, refined response below 20 Hz (not shown on graph).

3. Added advanced controls in Targets panel for the sub's low end rolloff. PBK's auto-detected settings are as always the only ones that are generally recommended - manual overrides are intended for use only with the proper tools and knowledge.


http://www.paradigm.com/downloads/pa...t/pbk/software

Enjoy!