|
|
![]() |
||||||||||||||||||||
|
Best Blu-ray Movie Deals
|
Best Blu-ray Movie Deals, See All the Deals » |
Top deals |
New deals
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]() $35.00 4 hrs ago
| ![]() $31.32 1 hr ago
| ![]() $22.49 10 hrs ago
| ![]() $49.99 | ![]() $36.69 | ![]() $29.99 | ![]() $31.99 | ![]() $68.47 1 day ago
| ![]() $29.96 | ![]() $29.96 | ![]() $96.99 | ![]() $86.13 |
![]() |
#1 |
Active Member
|
![]()
So after much internet surfing, I decided to build myself a Flexy Rack to house my Emotiva Amp, Turntable, LP's and Phono PreAmp. Couldn't find a 'pre-made' rack that would fit my space limitation so off I went to various local hardware stores to buy all the parts that would make up my rack (isn't much really).
Parts: 4 shelves (21" x 20") cut from a 4' x 4' x 5/8" piece of MDF. ($ 20.00) ****cut 2 'LP Rests' from the same piece**** 4 threaded rods (36") (I bought Zinc plated) ($ 32.00) 36 5/8" Zinc Plated Nuts ($ 18.00) 40 5/8" Zinc Plated Washers ($ 12.00) 40 5/8" Neoprene Gaskets ($ 45.00) - had to special order 4 5/8" Zinc Plated Acorn Nuts ($ 4.00) Primer & Paint were already in-house, but I figure ($ 25.00) 4 5/8" Plastic Furniture Leg Caps ($ 2.00) DSC00595.JPG All materials, and shelves drilled DSC00596.JPG "Dry fit" to make sure it all works DSC00599.JPG Prime and paint phase (3 coats) DSC00604.JPG Back together again. Emo on the bottom, then LP's, Pre Amp and top will be the Turntable. DSC00610.JPG In it's final resting place. Last edited by FreakyFraser; 03-16-2011 at 04:34 PM. |
![]() |
|
|
![]() |
|
|