Calling all computer "geeks" and such - Blu-ray Forum

Cisco in HD · 04-01-2009, 06:22 PM

I figured this would be a great place to get a few questions answered regarding my wireless router. I have a linksys WRT330N, and last night we had a pretty good rain/thunderstorm and where I live I lost power for a bit. After making sure everything was ok, I noticed a computer that's connected via wireless USB dongle my wireless speed is laggy to hardly nonexisitant. BUT my 360, main PC, and my roommate's laptop (all wired) all run without a hitch. Is is possible my router has a wireless circuit board that got fried? Or something inside that shorted and doesn't transmit a wireless signal?

Leopold BUTTERS · 04-01-2009, 06:53 PM

Quote:

Originally Posted by Cisco in HD

I figured this would be a great place to get a few questions answered regarding my wireless router. I have a linksys WRT330N, and last night we had a pretty good rain/thunderstorm and where I live I lost power for a bit. After making sure everything was ok, I noticed a computer that's connected via wireless USB dongle my wireless speed is laggy to hardly nonexisitant. BUT my 360, main PC, and my roommate's laptop (all wired) all run without a hitch. Is is possible my router has a wireless circuit board that got fried? Or something inside that shorted and doesn't transmit a wireless signal?

Try unplugging the router then plugging it back in, that should fix it for you.

brettallica · 04-01-2009, 06:56 PM

Quote:

Originally Posted by Leopold BUTTERS

Try unplugging the router then plugging it back in, that should fix it for you.

Ditto. I don't think I've ever seen a situation where only the wireless signal was permanently hindered or handcuffed as it were, so there's probably just something screwy going on in there and it needs a reset. Worst-case scenario (well not the worst, but the next step I guess you could say) would be to do a hard reset of the router. There's usually a depressed button on the chassis that you can only access with the tip of a pen or paperclip.

Cisco in HD · 04-01-2009, 07:14 PM

Believe me guys, that's not it. I restarted my modem, then my router in that order and it's worked before. But not this time, I even rebooted the router in the linksys setup page, and nothing. No settings have been altered. It happened last night after the power went out. I was able access pages last night but it was sluggish and today, no connection. I thought it could be the USB dongle, but when bringing up a page on my iPhone it can't even bring up the page. Any thoughts?

brettallica · 04-01-2009, 07:20 PM

Quote:

Originally Posted by Cisco in HD

Believe me guys, that's not it. I restarted my modem, then my router in that order and it's worked before. But not this time, I even rebooted the router in the linksys setup page, and nothing. No settings have been altered. It happened last night after the power went out. I was able access pages last night but it was sluggish and today, no connection. I thought it could be the USB dongle, but when bringing up a page on my iPhone it can't even bring up the page. Any thoughts?

Did you try the hard reset method? There's usually a button that'll allow you to reset everything that way. You might also try a firmware update just for kicks.

Cisco in HD · 04-01-2009, 07:32 PM

Tried that this morning. Also, I looked on linksys.com and I do have the latest firmware. So it's not that.

supersix4 · 04-01-2009, 09:58 PM

Quote:

Originally Posted by Leopold BUTTERS

Try unplugging the router then plugging it back in, that should fix it for you.

and also doing a reset on the back either a small button or hole u need to stick a pen in.

brettallica · 04-01-2009, 10:05 PM

Quote:

Originally Posted by supersix4

and also doing a reset on the back either a small button or hole u need to stick a pen in.

Already suggested.

jk

Bad8511 · 04-02-2009, 12:22 AM

Get a D-link! Seriously those Linksys are horrible! Perfect time to upgrade. I have the DIR-655 and I can tell you from experience with other routers including Linksys, the DIR-655 ROCKS!

PH3AR · 04-02-2009, 12:23 AM

Who are you calling "geeks"!

jk

Cisco in HD · 04-02-2009, 01:36 AM

It looks like my router is messed up. No matter what I do I can't get wireless activity. Thanks for your advice guys and "geeks" LOL. Looks like I'll be picking one up in the AM.

brettallica · 04-02-2009, 01:46 AM

Good luck with the new unit, and bummer that your old one had to crap out on you like that.

While I respect the words of the guy a few posts above, I absolutely despise D-Link at this point in my computer life. They screwed me over really badly one time on a replacement router, and I swore to never buy from them again.

Anthony P · 04-02-2009, 01:53 AM

did you try connecting it vis ethernet?
did you log into the router to make sure everything is set up correctly?

supersix4 · 04-02-2009, 03:23 AM

Quote:

Originally Posted by brettallica

Already suggested.

jk

lol I wasnt paying attention just read his help wanted and threw an answer up

Cisco in HD · 04-02-2009, 10:19 AM

Quote:

Originally Posted by Anthony P

did you try connecting it vis ethernet?
did you log into the router to make sure everything is set up correctly?

I have 3 things connected via Ethernet and I get a great connection. Now anything wireless, a spare computer that says it can't connect to my wireless
network, and 2 iPhones don't get any bandwidth even though the phones are connected via wifi. So it's odd. No settings have been altered and I've resetted the hell out of this thing. And it's still no go. Thanks for your replies.

Bad8511 · 04-02-2009, 11:49 AM

Quote:

Originally Posted by brettallica

Good luck with the new unit, and bummer that your old one had to crap out on you like that.

While I respect the words of the guy a few posts above, I absolutely despise D-Link at this point in my computer life. They screwed me over really badly one time on a replacement router, and I swore to never buy from them again.

The same frustration you have with D-Link is my frustration with Linksys. Horrible product IMO and tech support couldn't even help me get connected, wtf?, it's your job to help and you can't!

brettallica · 04-02-2009, 03:14 PM

Quote:

Originally Posted by Bad8511

The same frustration you have with D-Link is my frustration with Linksys. Horrible product IMO and tech support couldn't even help me get connected, wtf?, it's your job to help and you can't!

It's all good. They're all crooks out there.

BluHavik · 04-04-2009, 10:18 AM

Quote:

Originally Posted by Cisco in HD

I have 3 things connected via Ethernet and I get a great connection. Now anything wireless, a spare computer that says it can't connect to my wireless
network, and 2 iPhones don't get any bandwidth even though the phones are connected via wifi. So it's odd. No settings have been altered and I've resetted the hell out of this thing. And it's still no go. Thanks for your replies.

I had a lynksys and it sucked, get a new one. But are you saying iPhones don't work at all? I don't have one but my cell doesn't use the router to get online. Would a router be a problem for your phone?

RustyK94 · 04-04-2009, 05:32 PM

Make sure your router and wireless card both have a range of 300mbs and it suddenly stops working it's just a drop in connection which plauges every wireless network. Simply turn your router off and on that should fix the problem.

04-01-2009, 06:22 PM	#1
Cisco in HD Senior Member Member since:Jan 2009 Location:West Palm Beach, FL Trading Score:3	Calling all computer "geeks" and such I figured this would be a great place to get a few questions answered regarding my wireless router. I have a linksys WRT330N, and last night we had a pretty good rain/thunderstorm and where I live I lost power for a bit. After making sure everything was ok, I noticed a computer that's connected via wireless USB dongle my wireless speed is laggy to hardly nonexisitant. BUT my 360, main PC, and my roommate's laptop (all wired) all run without a hitch. Is is possible my router has a wireless circuit board that got fried? Or something inside that shorted and doesn't transmit a wireless signal?

Similar Threads
thread	Forum	Thread Starter	Replies	Last Post
"freaks And Geeks" & "undeclared"	Wish Lists	ChitoAD	12	11-25-2022 01:27 PM
Brett Ratner Doesn't Care What "Comic Book Geeks" Think	Movies	Galactus	172	09-14-2009 09:49 PM
Calling All Panny 'BD10A Owners: What "Picture Mode" Do You Use?	Blu-ray Players and Recorders	ClinicaTerra LTD	7	06-27-2008 06:34 PM
Stop calling them "Black Bars"	Display Theory and Discussion	cscBiology	26	03-22-2008 05:10 AM
UK gets "Kill Bill" 1&2, "Pulp Fiction", "Beowulf", "Jesse James", and more in March?	Blu-ray Movies - North America	JBlacklow	21	12-07-2007 11:05 AM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-01-2009, 07:14 PM	#4
Cisco in HD Senior Member Member since:Jan 2009 Location:West Palm Beach, FL Trading Score:3	Believe me guys, that's not it. I restarted my modem, then my router in that order and it's worked before. But not this time, I even rebooted the router in the linksys setup page, and nothing. No settings have been altered. It happened last night after the power went out. I was able access pages last night but it was sluggish and today, no connection. I thought it could be the USB dongle, but when bringing up a page on my iPhone it can't even bring up the page. Any thoughts?

04-01-2009, 07:32 PM	#6
Cisco in HD Senior Member Member since:Jan 2009 Location:West Palm Beach, FL Trading Score:3	Tried that this morning. Also, I looked on linksys.com and I do have the latest firmware. So it's not that.

04-02-2009, 12:22 AM	#9
Bad8511 Senior Member Member since:Apr 2008 Location:Louisville, KY Blu-ray collection:321 Trading Score:8	Get a D-link! Seriously those Linksys are horrible! Perfect time to upgrade. I have the DIR-655 and I can tell you from experience with other routers including Linksys, the DIR-655 ROCKS!

04-02-2009, 12:23 AM	#10
PH3AR Blu-ray Ninja Member since:Jan 2009 Location:Dover, Pennsylvania PSN:WORKINtheCORNER Home Theater Gallery:9 Blu-ray collection:325 Blu-ray reviews:2	Who are you calling "geeks"! jk

04-02-2009, 01:36 AM	#11
Cisco in HD Senior Member Member since:Jan 2009 Location:West Palm Beach, FL Trading Score:3	It looks like my router is messed up. No matter what I do I can't get wireless activity. Thanks for your advice guys and "geeks" LOL. Looks like I'll be picking one up in the AM.

04-02-2009, 01:46 AM	#12
brettallica Blu-ray Samurai Top ranked HT gallery Top contributor Member since:Nov 2008 Location:Santa Cruz, California Home Theater Gallery:51 Blu-ray collection:79 Trading Score:6	Good luck with the new unit, and bummer that your old one had to crap out on you like that. While I respect the words of the guy a few posts above, I absolutely despise D-Link at this point in my computer life. They screwed me over really badly one time on a replacement router, and I swore to never buy from them again.

04-02-2009, 01:53 AM	#13
Anthony P Blu-ray Count Member since:Jul 2007 Location:Montreal, Canada	did you try connecting it vis ethernet? did you log into the router to make sure everything is set up correctly?

04-04-2009, 05:32 PM	#19
RustyK94 Power Member Member since:Jan 2008 Location:Independent Republic Of Scotland Home Theater Gallery:2 Blu-ray collection:126	Make sure your router and wireless card both have a range of 300mbs and it suddenly stops working it's just a drop in connection which plauges every wireless network. Simply turn your router off and on that should fix the problem.

Best Blu-ray Movie Deals