Pioneer SC 27 & Logitech Remote

[DonRSD]

well my Logitech remote wont change HDMI inputs.
kuro link is OFF.

i have my remote setup that each input has its own button, yet i see the hdmi inputs have to be toggled to to get to them.

does anyone have any suggestions to fix this?

when i push an activity (tv surround, ps3, etc) the sc-27 turns on and all, yet it wont change to the proper input

[DonRSD]

ok so the input changes.
the issue im having is when the receiver is turned off (say watch tv with no surround) and i push to watch tv with surround or a blu ray, the sc-27 will turn ON yet wont switch to the proper input (it stats on the last input)

i have to push activities and re push watch tv with surround or ps3, once the receiver is on, for it to change inputs.

any suggestions?

[DonRSD]

got it figured out.

here is what i did in case anyone else ever has this issue.

devices > picked my sc-27 SETTINGS> adjust the delays > power on delay = 3500 (everything else 0)



Power On Delay.
When a device receives a PowerOn command, it takes a certain amount of time to "warm up" the device and resume normal operation. For most devices this happens very quickly, but for some devices, such as televisions and receivers, it can take up to 3000 milliseconds (three seconds).

Inter-key Delay.
When a device receives an infrared command the device is considered"busy" while it processes the command. The amount of time required before the device will respond to another command is known as the inter-key delay, and normally ranges from zero to 300 milliseconds. Devices with long inter-key delays take longer to respond to multiple infrared commands (e.g., when changing television channels).

Input Delay.
When a device switches inputs (e.g. goes from Video 1 to Video 2) the device is considered "busy" while it processes the command. The amount of time required before the device will respond to another switch input command is known as the input delay, and normally ranges from 500 to 3000 milliseconds. Devices with long input delays take longer to change inputs.

Inter-Device Delay.
When an infrared command is sent for a particular device, each device in your system will receive the command, but only one will respond to it. The other devices will ignore the infrared command. Sometimes, when this happens, a device will ignore the infrared signal and then stop accepting infrared commands for a period of time. This period of time is known as the inter-device delay. During this time no infrared signals are generated by the remote. In rare cases this delay can be several seconds.

[crackinhedz]

I was gonna say, try adjusting the delay...but you seemed to figure it out.


also, you can set which order items turn on first...I have it set to always turn the TV on first, then receiver, then dvd/bluray player.