PS3 to Onkyo 605 - Help needed!

[CharlestonLion]

OK, I just got a 605 as my first receiver, but can not get the picture or sound to flow through. I need some advice....

Here is what I have so far....

On the 605 I went under Input/Output Assign and did two things:

1. Under "Monitor Out" I switched "HDMI Monitor" to "Yes"....then I was able to get the set up screen to appear on the TV.

2. Under "HDMI Input" I set "Game/TV" to IN 1.

The HDMI cable going from the PS3 is inputed in "Input 1" on the back of the receiver.

On the PS3 I have these things set:

1. Video Settings:
-BD/DVD Audio Output Format (HDMI): Set at Linear PCM
-BD Audio Output Format (Optical Digital): Set at Linear PCM
-BD 1080p 24 Hz Output (HDMI): Set at Automatic
-BD/DVD Video Output Format (HDMI): Set at Automatic

2. Display Settings:
-Video Output Settings: Current Output Resolution at 1080p
-RGB Full Range (HDMI): Set at Full

3. Sound Settings:
-Audio Output Settings, Under the Settings List:
--Connector Type: HDMI
--Output Format:
---Linear PCM 2 Ch. 44.1 kHz
Linear PCM 2 Ch. 48 kHz
Linear PCM 5.1 Ch. 44.1 kHz
Linear PCM 5.1 Ch. 88.2 kHz
Linear PCM 5.1 Ch. 176.4 kHz
Linear PCM 5.1 Ch. 48 kHz
Linear PCM 5.1 Ch. 96 kHz
Linear PCM 5.1 Ch. 192 kHz
All the 5.1 listings I manually added.

These are all connected to a 50" Samsung 1080p Plasma. I can't figure out why the video and audio is not making it through. When I switch to just feeding an HDMI from the 605 to the TV, I can get the visual because my settings screens were appearing on the TV.

Thanks in advance for any helpful tips you all can supply to me!

Oh, and one last thing....I have a 5.1 speaker system in the room, but do not have the speakers connected to the 605 yet. I figured I would first try to get the PS3 connected and then worry about the speakers later.....I will probably post again for helpful hints on getting the speakers up and running at that time too!