Denon AVR-2309ci Banana Plugs?

[jc480]

I need to hook my Denon AVR-2309ci up to my in-wall speaker jacks (they are banana plugs...note picture in HT pictures).

Anyway...my stupid question is...do I use my existing roll of speaker wire with 1 end banana plugged and the other end I strip the jacket and insert into the receiver input?

Or do I make my speaker cables with banana plugs on both ends?

A bit confused on this. Does the Denon receiver accept banana plugs into the speaker jacks because all the illustrations appear to call for the speaker wire ONLY going into the jack.

[ZIPPO]

Your receiver accepts banana plugs, bare wire & spades.

[Sammy]

I put banana plugs in my 889 which is the same as the 2309 with the exception of the extra remote and RS-232 port. They work fine.

[Cisco in HD]

A banana plug on the red wire, one on the black wire... At both ends. I have the 1909 and it takes them beautifully.

[jc480]

Thanks folks