Definitive Technology BP7006 question

[eric1111]

I noticed they are not marked LF Or RF so it doesnt matter where they go. Thanks.

[MrFattBill]

Originally Posted by eric1111

I noticed they are not marked LF Or RF so it doesnt matter where they go. Thanks.

You should try them both ways and see which one sounds better to you, it even says to do that in the manual

Bill

[DragonSarc]

nope it does not matter its up to you where or which side to put it on but the normal way i think is the tweeter should be in ward if that helps

[Big Daddy]

Originally Posted by eric1111

I noticed they are not marked LF Or RF so it doesnt matter where they go. Thanks.

This question has been asked multiple times in https://forum.blu-ray.com/speakers/8...rs-thread.html. In fact, I responded to exactly the same question a few days ago. I copied my response from Post #787 of that thread.

From page 4 of the BP7002/BP7004/BP7006 manual.

http://www.definitivetech.com/docume...12009_read.pdf

The BP7002/BP7004/BP7006s are mirror imaged (packing cartons are labeled speaker 1 and speaker 2) with a flat-coned radiator on the bottom of each side and one active driver above one of the radiators (which you can feel through the grille cloth). The side-mounted subwoofers are located so they may be set up with both higher mounted active woofers facing in (toward each other) or both active woofers facing out (away from each other). (Feel the side of the speakers to determine which side the higher mounted active woofer is on.) Facing the active woofers in or out will vary the sound somewhat and which way is best will vary with your room. Usually, we start with the active woofers facing in as this is often the way it sounds best. Again, experiment to determine the best location for the speakers.