Polk PSW10 Settings

[Fors*]

What are the best settings on the PSW10 sub with a Onkyo 605 for the 2 scenarios?


1) Using a single cable into the Line In (Left or Right - No LFE on this sub) on the sub from the subwoofer out on the 605:

A - Set to Fullband (this is Large on the 605) or not?
B - If not, what hz should be set on the crossovers for the sub with Polks T90e's and center CS10?


2) Using the Y splitter into the L and R Line In (No LFE on this sub) on the sub from the subwoofer out on the 605?

A - Set to Fullband (this is Large on the 605) or not?
B - If not, what hz should be set on the crossovers for the sub with Polks T90e's and center CS10?

It could be the same settings for both for all I know, but I wanted to ask to make sure. Any help is greatly appreciated!