Quote:
Originally Posted by forsberg21
Technically not fireman, as the LFE signal only goes up to 120Hz anyway. Most people set theirs at 120Hz, so setting it at 150Hz is really the same as 120hz when you think of it.
What stinks is with this setting at 150Hz you would get absolutely no low end being pumped out from your fronts......  |
Fors wouldn't it be a little bit of a better compromise to set the crossover at 100Hz then instead of 80 so its in the middle between where the sub really should be (120Hz) and where the speaker should be (100Hz)? That way your still getting everything up to the 100Hz mark from the LFE channel and your not losing anything from the speakers since it would still be sent to the sub if it goes below 100Hz.