Quick question 1st time setup Onkyo Audyssey

[Collectors Set]

I have 5 total speakers + sub. So it goes through and correctly identifies my fronts and center. But it only picks up a Surround Back Right and not the left. So obviously I swapped speakers and same thing, only picks up Surround Back Right. But by swapping I know that the problem is not with the speakers because both of them made the zapping noise nor is it my connections. It has to be the Surround Back Left terminal on the receiver?? Any suggestions appreciated

[un4gvn94538]

i would play something in surround and check if the audio is coming out of that speaker. put your ear up to it

[Collectors Set]

OK -- good idea...I just unplugged the sub and made sure the terminal posts on the receiver were nice and tight on the back surround left inputs. And still nothing. It then prompts me to either retry or cancel.

Wonder if I used them as Surrounds instead of Surround rears. Would they still be in play for like a 5.1, or should you only use the surrounds in a 7.1 scenario. In other words is there a priority of order you should follow between these two pairs??

[un4gvn94538]

i would say there is a priority especially in descrete channels. did you try my suggestion? is there still no sound?

[Collectors Set]

Originally Posted by un4gvn94538

i would say there is a priority especially in descrete channels. did you try my suggestion? is there still no sound?

sorry there is gonna be lag of me running back and forth....in one minute I will :-) so what you are saying is that in a 5.1 setup, you really should only go with surround rears as opposed to surrounds??

Just for giggles, I plugged the same two speakers into the surrounds terminals and the Audyssey did properly pick them both up....

[un4gvn94538]

well if your going to listen to a 5.1 movie which most is, then your going to miss a surround. you cant assign a channel to a terminal

[Driver_King]

Originally Posted by Collectors Set

Just for giggles

WTF is that? Giggles dare you say!