Bitstreaming to Yahama: Which PCM Output?

[Penitus]

Hey gang. I've had my Yahama receiver for about a week or two now and I love it, but there's just one setting on my Blu-Ray player (Sony) that I may have set incorrectly.

PCM Output signal...do I want:

48 kHz / 16 bit
or
96 kHz / 24 bit

?

Thanks for your help in advance.
-Matt

[crackinhedz]

96 kHz / 24 bit


but...


what model player and receiver do you have? connected by HDMI?

[Penitus]

Originally Posted by crackinhedz

96 kHz / 24 bit


but...


what model player and receiver do you have? connected by HDMI?

Sony S350
Yahama RX-V663

Connected by HDMI.

[crackinhedz]

set the BD player to "Direct", not Mix.

[Penitus]

It already is. Here are my settings:

Audio Output Priority: HDMI
Audio (HDMI): Auto
BD Audio Setting: Direct
Audio ATT: Off
Dolby Digital: Dolby Digital
DTS: DTS
48kHz/96kHz: 96 kHz/24 bit
Audio DRC: Wide Range
Downmix: Dolby Surround

Isn't this what I want? Is it correct?

[BIslander]

Originally Posted by Penitus

It already is. Here are my settings:

Audio Output Priority: HDMI
Audio (HDMI): Auto
BD Audio Setting: Direct
Audio ATT: Off
Dolby Digital: Dolby Digital
DTS: DTS
48kHz/96kHz: 96 kHz/24 bit
Audio DRC: Wide Range
Downmix: Dolby Surround

Isn't this what I want? Is it correct?

Yes, those are all correct. Use 96/24 if your receiver supports it. Otherwise use 48. There aren't all that many discs with 96kHz PCM sampling rates where this seting will come into play.