Panasonic Blu-Ray w/ Yamaha Receiver - NO VIDEO

[un4gvn94538]

k, here we go...


i hooked up the player to my receiver via hdmi and component to the receivers component input 1 and hdmi input 1.

the receiver is hooked up to tv via hdmi out to tv dvi input. i select the tvs dvi input then forget it because my receiver will output component in via hdmi and the receiver set up menu is set to output via hdmi as well.

in my receivers set up menu i assing component input 1 to 'vcr' (hdmi is not assigned yet) and exit. the player should show up. i configure the compent resolution on the player.

in the player menu (viewing via component), under tv/device connection, and then under hdmi connection, hdmi resolution is unselectable regardless if hdmi is on of off on the player.

with the player menu still up, i bring up my receiver menu which overides the input video, and assing hdmi 1 to 'vcr' so that both component and hdmi are assigned. exit. now the player menu is shown.

back into hdmi connection on the player menu, hdmi resolution now selectable as well as the other settings. i changed the resolution from 1080p to 1080i and configure the rest BUT not the hdmi on/off. only turn hdmi to on when your done with the other settings.

back into the recevier menu, i deselect the component input from 'vcr' so that only hdmi is assigned. ext.

now viewing player menu via hdmi in 1080i.

as i said before, if i turn off the tv and or receiver first, sometimes the player resets itself so i have to do this again. so i make sure i tun off the player completely first then everything else so i dont have to do this again but i leave the component cables hooked up just in case.

i hope i made it easier to follow this time

edit: forgot to mention besides turning it off first so it doest reset itself, but also to turn it on last when you watch a movie.