Pio 1018

[Al Bundy]

Since i got my kuro. I have been having a delay with my audio. Around half a sec. I did auto cal on the a/v, still the same problem. Next step?

[callas01]

not familiar with the workings of the 1018, but on the sony i have there is an audio sync feature where you can manually adjust the dialog to speed up or down to match what is on the screen, see if you have that too and try playing with it.

[Al Bundy]

No one has this reciever or any idea how to fix this?

[Al Bundy]

?

[got rice]

Does either the 1018 or the KURO have a PLQS option? this will eliminate any delay's caused by timing errors. I think this is refered to as "jitter"

or maybe a "synchronization mode"?

[Al Bundy]

Thanks. I will take a look at home. I doubt the Kuro will have it but doesnt hurt to check. The only option I've seen on the a/v is Delay FR (frames) but doesnt seem to help. Ill take a look at the manual tonite.

[JasonR]

Setting the Audio options
There are a number of additional sound settings you can
make using the Audio Parameter menu. The defaults, if
not stated, are listed in bold.
Important
• Note that if a setting doesn’t appear in the Audio
Parameter menu, it is unavailable due to the current
source, settings and status of the receiver.
1 Press RECEIVER, then press AUDIO PARAMETER.
2 Use Up/Down to select the setting you want to adjust.
Depending on the current status/mode of the receiver,
certain options may not be able to be selected. Check the
table below for notes on this.
3 Use Left/Right to set it as necessary.
See the table below for the options available for each
setting.
4 Press RETURN to confirm and exit the menu.
Setting What it does Option(s)
MCACC

DELAY
(Sound Delay)
Some monitors have a slight
delay when showing video, so the
soundtrack will be slightly out of
sync with the picture. By adding a
bit of delay, you can adjust the
sound to match the presentation
of the video.
0.0 to 6.0
(frames)
1 second = 30
frames (NTSC)
Default: 0.0

http://www.pioneerelectronics.com/St...ctions0610.pdf

Page 71

[Al Bundy]

I've been f*cking with this option all sunday. I couldnt get it to sync. Was getting frustrated. Let me try again tonite.

So how does this work. 1 second means .3 or is it 3? And what does that mean u can change the delay by 2 seconds if its 3?

[Al Bundy]

Can anyone tell me what is the exact delay on the Kuro or someone with same equipment. Basic ideas? Right now its at 1.3 and its still off.

Kuro 101
Ps3
Pioneer 1018
Bell Expressvu Sat.