Now available - Yamaha RX-V1800/3800 firmware update with DTS-HD MA fix!

[Crème Blu-ray]

Note: This has already been posted here but I felt it was important enough to merit its own thread.

Yamaha has posted the official USA firmware fix for the DTS-HD MA bitstream "pop" issue. I just tried it with The Fly (@ 13:00) and the dreaded pop is gone!

Originally Posted by Yamaha Electronics Corporation, USA

Newly Released Firmware for RX-V1800 & RX-V3800.

Thank you for your patience with regards to the firmware for the RX-V1800 and RX-V3800. Yamaha has just released the official firmware for these models, which you the consumer can download at your own convenience through the Yamaha website. Simply click on the following link listed below, which will take you directly to our website, and the product download page. Just follow the directions as indicated, and you will be able to perform the firmware update yourself.

RX-V1800:
http://www.yamaha.com/yec/products/productdetail.html?CNTID=558291&CTID=5000300&RLTID =1505&DETYP=RELATION

RX-V3800:
http://www.yamaha.com/yec/products/productdetail.html?CNTID=558316&CTID=5000300&RLTID =1505&DETYP=RELATION

If you have any further questions regarding the firmware's contact our customer service department Monday through Friday from 8:00 a.m. to 4:00 p.m. (PST) for further assistance. Again, than you for your patience with regards to this matter.

Sincerely;
Yamaha Electronics Customer Support Team

[AnimeOnBlu]

Doing the update right now. Thank you Yamaha!

Edit- Finished updating and everything is working perfectly. "The Fly" no longer has the pop.

[zak88lx]

Thank you Yamaha and also a big thanks to the OP!!!

Thanks,
Zak

[zak88lx]

I applied the firmware and it went through without a hitch.

Zak

I play content via a PlayStation 3, so fortunately never experienced the popping issue; I am, however, experiencing loads of HDMI-related problems. Does anyone know what bugs were fixed with this update?

[Squozen]

Originally Posted by Holograph

I play content via a PlayStation 3, so fortunately never experienced the popping issue; I am, however, experiencing loads of HDMI-related problems. Does anyone know what bugs were fixed with this update?

Nothing HDMI-related, to my knowledge. Which of the receivers do you have?

There was another recent update that allowed the receivers to pass blacker-than-black signals, have you installed that one?