Just bought a Klipsch sub 10 and need help.

[backtothecanvas]

Originally Posted by Big Daddy

• On the back of the sub, turn the crossover to its maximum point. You will set this in your receiver's menu.
• On the back of the sub, turn the level to 60%.
• On the back of the sub, set the phase to zero.
• In the receiver's menu, make sure the subwoofer and all speakers are turned to ON.
• In the receiver's menu, set all speakers to SMALL.
• In the receiver's menu, set the HIGH PASS FILTER (crossover frequency) of each speaker about 10Hz to 15Hz higher than the stated low end frequency response of each speaker (this number is stated in the speaker's manual or the manufacturer' website).
• In the receiver' menu, set the HIGH PASS FILTER of the subwoofer to 120Hz.
• Run the calibration program again.

You can adjust the settings slightly if you don't like the results of the calibration, but don't overdo it.

i have the pioneer elite sc-05 i did a lot of what you mentioned. im not understanding where i change the "high pass filter" of each speaker including the sub as well. the overall setting for the crossover is at 80hz.