My Speaker Setup, Help..........

[JPOPPEREZ]

I have Onkyo 606 reciever
Monitor 50s for fronts
Monitor 30s for rears
Polk CS1 for Center
Energy ESW-V10




I just want to make sure I'm getting the best sound out of my system I ran audessey and these are the speaker calibrations that it set the speakers up with:


They are all set to 80hz except the sub that is at 120hz and the volume level is 1 pass high way up. the phase is at 0 too

Fronts are -4.0 d.b.
Rears are 0.0 d.b
Sub is -15.0 d.b

Thank you for the help

[turboLAZER]

Originally Posted by JPOPPEREZ

I have Onkyo 606 reciever
Monitor 50s for fronts
Monitor 30s for rears
Polk CS1 for Center
Energy ESW-V10




I just want to make sure I'm getting the best sound out of my system I ran audessey and these are the speaker calibrations that it set the speakers up with:


They are all set to 80hz except the sub that is at 120hz and the volume level is 1 pass high way up. the phase is at 0 too

Fronts are -4.0 d.b.
Rears are 0.0 d.b
Sub is -15.0 d.b

Thank you for the help

audyssey adjusts these settings based on room dimensions and how close the speakers are to the setup mic. nobody here will be able to tell you if these numbers are correct. although the LPF for the sub at 120HZ seems a little high, you may want to try a lowering it to 100HZ or 80HZ and see if if sounds more natural

[ryandubbz]

First off read through this thread from page 1, https://forum.blu-ray.com/audio-theo...ml#post4107548

also your sub volume level is to high, you dont want audessy to set it lower than -12db.

[JPOPPEREZ]

how is the sub to high is its -15 minus 15

[ryandubbz]

im guessing your receiver goes from -15 to 0 to +15 ????

If this is the case, audessy is setting your sub all the way down to -15 because the volume level is set to high on the sub.

[JPOPPEREZ]

I turned it down to half way and do I chage the lpe on the reciever or the back of the sub?