Transformers 3 7.1?

[HAMP]

Originally Posted by Almadacr

Hey Hamp , yes you can change the values from each speaker individually even after MCACC is set like X-over etc , also you brought a good point , this AVR can do High's/wide also but doing so it cancels the back surrounds .

Other thing is it should show "Direct" on the front in red but if you are using front highs it cancels the back surrounds and it makes this a 7.1 and not a 9.1

I know you can make adjustments, I was wondering if he was able check each speaker in the setup.

I was kinda tired and I didn't type it out properly.

Originally Posted by shayneca

Thaks everyone for the feedback when I get home tonight I will try again. Everything is connected as it should it says you can use zone 2 also as front high but playing the movie I get nothing from front high or surround back.

When you get home, can you go into the menu where you are able to make db adjustments to each speakers. I would like you to test to make sure you have audio from each individual speaker. You are able to select each speaker and you will/should hear an audio sound that you can raise or lower, but I just want to know if you can hear anything from each one.