HELP PLEASE: Failed to enable HDCP. <- Fixed: see post # 25

[russianwolfy]

Hello All,

I'm new to the whole Blu-Ray PC setup.. Below are my system specs:

Motherboard: Asus Striker Extreme nVidia 680i SLI
CPU: Intel Quad Core Q6600 8MB Cache
Video Card: Asus EN8800ULTRA/HTDP/768M/A GeForce 8800 ULTRA 768MB DDR3 PCI Express, HDTV HDCP
Optical Drive: Sony Blu-Ray Burner BUW-100A
HP HP100 HD-DVD External Drive
Monitor: Dell 30" 3007WFP-HC
Vista Ultimate 32Bit with nVidia Forceware 163.69.
PowerDVD Ultra v7.3

I'm trying to play Blu-Ray & HD DVD movies on my PC but i can't. I run PowerDVD and try to play a movie and all i get is this message "Fail to enable HDCP. Please switch to analog output (VGA, D-Sub) and try again. (Error Code = 0110)" in both BD & HD.
I have no idea what that is.. i tried researching the internet for some answers but couldnt find anything. One site recommended that i install ****** HD and i did... and when its enabled i can only run HD DVD movies which ran smooth and problem free. But still get the same error when running Blu-Ray movies with ****** HD enabled.

A scan on the Cyberlink Advisor gives me all green lights (in both BD/HD) except a gray light (which means unknown) next to the graphics card which is the nVidia GeForce 8800 Ultra and RED light (which means NO) next to the Video Connection Type saying : "Digital (Without HDCP)".

I'm very frustrated and sad and i now currently have a useless blu-ray drive which i bought for a lot of money sitting in my PC doing nothing and i'm very anxious to watch my humble collection of 20 BD/HD movies that i own.

Please help me with your knowledge and expertise. I beg you.

Thanx in advance.