|
|
![]() |
||||||||||||||||||||
|
Best Blu-ray Movie Deals
|
Best Blu-ray Movie Deals, See All the Deals » |
Top deals |
New deals
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]() $74.99 | ![]() $101.99 13 hrs ago
| ![]() $23.79 8 hrs ago
| ![]() $124.99 1 day ago
| ![]() $24.96 | ![]() $70.00 | ![]() $35.99 1 day ago
| ![]() $24.96 | ![]() $29.95 | ![]() $33.49 | ![]() $99.99 | ![]() $33.49 |
![]() |
#1 |
Expert Member
|
![]()
Is when the identifier sticker (the one that goes around the top and sometimes sides and bottom) is stuck to the paper art. On a few of my releases I have had the top layer where the art is rip off leaving a long white strip where the art used to be. I try so hard to get ones that don't have the art under the sticker but sometimes I still get it. Anyone else ever happen to have this problem?
|
![]() |
![]() |
#2 | |
Active Member
|
![]() Quote:
|
|
![]() |
![]() |
#5 |
Member
|
![]()
I have had this happen but I can usually get it off intact with some goo gone and if needed a razor blade between the paper and sticker. If you soak the goo gone on the sticky area you will think you are going to stain the insert but it actually dries up pretty well and is un-noticable. Sometimes I will take a razor blade dip it in goo gone and use the razor to seperate the sticker. make a little progress then redip in goo gone. to each his own though
![]() Ant |
![]() |
![]() |
#11 |
Blu-ray Guru
|
![]()
I encountered this problem a number of times when I was collecting DVDs (which is why, to this day, I examine all in-store purchases) but in the year I've been collecting Blus, I've only had this happen once; my copy of the Scream set that was released two weeks ago is missing black from both the lower front and back of the sleeve. Ordered through AMZ, though, so there was no checking before purchase.
![]() |
![]() |
![]() |
#14 | |
Banned
|
![]() Quote:
![]() |
|
![]() |
![]() |
#15 |
Blu-ray Ninja
|
![]()
All stickers in general are obnoxious. Ive never had the problem with the identifier sticker. But I had one where there was this rectangular sticker on the top-back that was half on the actual case and half on see-through thing were the slip goes in, and it came off so terribly that I had to use one of my back-up cases to replace it.
|
![]() |
![]() |
#18 | |
Blu-ray Archduke
|
![]() Quote:
![]() The thing that I hate the most in regards to packaging is when the plastic wrap ends up sticking to the case. The worst is when it sticks badly to the spine and it can't be pulled off. I had to use one of my replacement cases for X-Men: First Class because a good portion of the spine was covered in plastic that was really stuck to it. |
|
![]() |
|
|
![]() |
![]() |
|
|