|
|
![]() |
||||||||||||||||||||
|
Best Blu-ray Movie Deals
|
Best Blu-ray Movie Deals, See All the Deals » |
Top deals |
New deals
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]() $27.57 14 hrs ago
| ![]() $44.99 | ![]() $31.13 | ![]() $27.13 13 hrs ago
| ![]() $24.96 1 day ago
| ![]() $29.99 1 day ago
| ![]() $54.49 | ![]() $30.50 20 hrs ago
| ![]() $34.99 | ![]() $99.99 46 min ago
| ![]() $34.99 | ![]() $70.00 |
![]() |
#1 |
Active Member
|
![]()
I have a KEF 5.0 system with a Martin Logan Dynamo sub (see my sig) along with an Onkyo 674 and I am wanting to potentially pick up an amplifier from Emotiva as it is a good value for the money and well-rated. My question which is barely addressed by the KEF website is how much power from an amplifier would be too much?
I realize that before I can even get an amp, I'll have to replace my receiver because the 674 does not have pre-outs. I'll likely upgrade to the Onkyo 706, but I will entertain the Yamaha RX-V663 or maybe something from Denon. The three front speakers have power ratings from 15-150W. So is it dangerous to throw 200W at them? I was looking at the XPA-3 http://emotiva.com/xpa3.shtm. The other issue is if that is dangerous then the UPA-7 is out too because my rears can only handle 100W and the 125W through 7 channels would be too much for them. Please Help! |
![]() |
|
|
![]() |
![]() |
||||
thread | Forum | Thread Starter | Replies | Last Post |
Speaker receiver question | Home Theater General Discussion | TTC1984 | 8 | 08-13-2009 09:52 PM |
Receiver and speaker question | Home Theater General Discussion | lforigno | 10 | 08-07-2009 11:18 PM |
Question on speaker cords for my receiver | Receivers | jc480 | 0 | 01-14-2009 10:18 PM |
Receiver and speaker question. | Home Theater General Discussion | bgbball31 | 2 | 08-19-2008 07:45 PM |
receiver & speaker setup | Audio Theory and Discussion | callas01 | 2 | 08-12-2008 06:20 AM |
|
|