Who doesn't like the Iron Man cover art?

[NJMetsFan]

For those that don't like the slip cover on Iron Man and don't like the cover art, you can try what I just did. I modified the slip cover and made it my cover art. That is if you were planning on throwing out the slip cover anyway or not using it.

Step 1. Cut the slip cover down the middle on the right where you will need the opening to be.

Step 2. Cutoff the top area that is Blue with the Blu-ray logo.

Step 3. Turn slip cover over and center the cover art on top of the opened slip cover. Make sure the center of the slip cover and cover art are lined up. Draw a cut line around the slip cover with a pen or pencil using the cover art as a guide. Then cut along that line.

I also decided to cut the bottom portion so I line up the cover art along the top edge.

Step 4. Not neccessary but it makes it fit better in the case. I took the cut up slip cover and went to each corner, used my nails, and peeled away basically the layer of card board. This thins out the slip cover significantly. It gives it a better fit. If you don't do this step, the cover will fit but it forces the BD case to open it self. It also makes it hard to engage the clips to close the case.

Step 5. Insert the modified slip cover over the cover art in the BD case. I only did this so i won't have a hole in the area of the UPC.

The pictures were taken after completion. I didn't think about taking pictures while I was doing it. Plus I wasn't sure how it would come out. Sorry about the quality of the pics. It was taken with my phone.

Iron Man s4.JPG
Iron Man s2.JPG
Iron Man s3.JPG