mounting my 54" panny plasma on a wall bracket

[HAMP]

Originally Posted by DonRSD

• is the bracket THAT EASY to install? Yes all of it's just that easy
• will all of the holes be on a stud/piece of wood? Once you find a stud, the next one over should be 16in. That is 16in from center of one stud to the center of the other stud. You will put the screws into the top part of the mount and bottom part. I went a little over board and put some into the drywall also. I only did for extra support, but it wasn't needed.
• should i use longer bolts since i have a 54" panny plasma? You will have the proper bolts in the mount kit that comes with it.

I can't remember if this was in the vid or not.

(1) I would pre-drill with a drill bit about half the lengh of the bolt.

(2) Use a rachet to hand screw the bolt all the way into the stud. Take your time with this part. No need to rush.

I did both on mine, the Samsung 40" in the bedroom and Panasonic 65" in my basement.