Spearker wiring question

[stevemoore99]

We are about to start some home remodeling and I have a speaker wiring issue.

I want to wire the room so the equipment can be in one of two places. The room is fairly large and so we have a fair amount of flexibility on positioning The Sony LCD , Sony Receiver, HD Rx, etc. However, the speakers will be in the same place in either case.

I am going to supply a speaker junction box and wall plate similar to this one.



So the setup will be that either wall plate 1 is used or wall plate two, but never will both be used at the same time. So how should I wire the two wall plates and boxes to the speakers? Am I correct in believing that since the signal on the speaker wires is pretty low frequency, that I could use just about any method of connection?