HELP WITH SONY s550

[Moefiz]

Originally Posted by slytown

Hey guys i just plugged my new bd player in through hdmi and i was doing the basic settings in the beginning... and when i was asked what type of video output resolution for the tv and i selected 1080p by accident and now i get no signal to my tv.. i do not know what to do.

if any one could help it would be greatly appreciated! THANKS

You should be able to go back into the set up menu and redo the set up.

[slytown]

Originally Posted by Moefiz

You should be able to go back into the set up menu and redo the set up.

Yeah i would do that but nothing is showing up on the screen now, so i dunno what im gonna do.

[Moefiz]

You should be able to reboot to the factory default settings check your manual.

[ozzman]

Use a video cable
So your useing HDMI and the cable.Do all your setting then unhook the cable to see if you got the picture you want with HDMI(do you understand)

It takes a little time but will help you get there

I've had to do this before not with a Blu-player.But other equipment

Good luck

[slytown]

Originally Posted by ozzman

Use a video cable
So your useing HDMI and the cable.Do all yor setting then unhook the cable to see if you got the picture you want with HDMI(do you understand)

It takes a little time but will help you get there

I've had to do this before not with a Blu-player.But other equipment

Good luck

I dunno i already selected hdmi and than i went to put in the resolution and than i clicked the wrong one and now i have no picture. I have tried putting in the standard av cables and i dont get anything on that now.. i if there is somewhere i can reset the player or sumthing so i can just restart the process over? thanks for the help already guys

[callas01]

you can reset the player and that will take you back to the startup procedure in most cases, or go into the setup menu and under Video or display and change the output to whatever you need..... resetting may be easier though, check the manual in the trouble shooting section.

[ozzman]

Originally Posted by callas01

you can reset the player and that will take you back to the startup procedure in most cases, or go into the setup menu and under Video or display and change the output to whatever you need..... resetting may be easier though, check the manual in the trouble shooting section.

Yea,I think all player have a reset just some are harder to find

[poogie]

Try pressing the stop button "square" on your player for more than 10 seconds, it should reset the video resolution to the lowest resolution. Check page 58 on your manual. Good luck

[slytown]

Originally Posted by poogie

Try pressing the stop button "square" on your player for more than 10 seconds, it should reset the video resolution to the lowest resolution. Check page 58 on your manual. Good luck

LOVE U!

thank you to all who helped out! Merry christmas!